AF+ Multi-Program
Phone: (02) 9790 2717
|
Standard Features |
|
Delay start: Allows you to postpone the start of the firing cycle up to 100 hours. Full On / Full Off (Maxiumum Ramp): User Program option to heat the kiln as fast as possible or to cool as fast as possible. Thermocouple Offset: Allows the operator to adjust the temperature display accuracy by as much as ±25°C (±45°F) to offset aging thermocouple(s). Program Review: Allows the operator to Review the entire firing schedule before or during a firing. Threshold Alarm: Allows the operator to program an audible alarm that notifies when the kiln has reached a working temperature. Thermocouple Alarms: Notifies the user of a defective thermocouple or a thermocouple that is connected with reverse polarity. Power Fail Recovery: Allows the kiln to resume the firing when power interruptions occur from thunderstorms or accidental shut-down. Safety Temperature limits: Allows the us to set a limitation to the top programmable firing temperature Either 1000C or 1300C. |
Click Here to Download a Brochure as a PDF
|
|
|
|
Technical Specifications |
|
|
. |
|
|
Input Voltage |
24vac center-tap transformer (50/60Hz) |
|
Voltage Tolerance |
+ 10% to -20% |
|
Operating Current |
200ma |
|
Operating Temperature |
0°C to 70°C (32°F to 158°F) |
|
Programmable Temperature Range |
0°C to 1300°C (32°F to 2400°F) |
|
Output Voltage |
2 Channels @ 12vdc/200ma |
|
Display Resolution |
1°C or F |
|
Analog to Digital Resolution |
24 bit |
|
Accuracy |
+/- 2°C |
|
. |
|
Digital Temperature Controller
NEW: The Autofire Plus is now available with up to 9 user defined programs. Each program can contain up to 8 heating or cooling rates, 8 target temperatures and 8 hold periods.
Easy to Use:
- 1st: Set the Ramp Rate (How many Deg C per Hour you want to go UP or DOWN)
- 2nd: Set the Desired Temp Deg C
- 3rd: Set the Soak (Ie Time to dwell at that Temp in HR:MM)
Then Repeat for as many (max of 8) or as few (min of 1) steps as you like.
Copyright © 2010 Woodrow Kilns Pty Ltd